We know some people have been having a few issues with the precision glue press, so we thought we'd gather all the helpful tips and information together in one place.
- Make sure that the bottle is pushed all the way in the press.
- Make sure to place the press in the holder all the way and that the nozzle is screwed onto the bottle properly.
- Check to make sure the tip of the applicator is touching the silicone circle when it's resting in the stand.
- Always place the press into the stand immediately after use - do not leave the press on your desk - the stand is what "caps" your glue.
- When you pick it up to use, there may be a glue plug that has formed at the tip - this is normal and part of what keeps the tip sealed. Pull it off by pinching the tip with your fingertips or nail.
- Make sure that you have the best tip for the type of glue you use. Thicker glue uses the grey tip. Thinner uses the white or clear tip.
- This press was designed for the Nuvo glue the tool comes with - if you are using other glues, please note that you may have to adjust for that, especially with glues with a higher water content - you may need to cap those after each use.
- You may have to squeeze the handle a tiny bit more to get it flowing after sitting too long.
- Drier climates may impact you depending on the glue you use, so adjust as you need to.
- If you are still having issues. Open the bottle and see if there is an obstruction in the nozzle such as coagulated glue.
- Make sure the barrel of the applicator is clear before capping.
Here's some helpful videos to watch.
Everything you need to know.
This video talks about the tips.
You can find the Glue press here and replacement bottles and nozzles pack here